Re: Newbie

["Victor Laury" <vlaury@earthlink.net>]

>once it starts slipping really bad, won't you glaze the assembly
---------
Arthur,

True, or worse you can wear to the rivets and cut the pressure plate and fly
wheel.

But, You don't want to do this job twice. Pull the engine and replace the
pressure, clutch disk, Throw out bearing and guide bush with new parts. I
strongly suggest that you upgrade to a 2000 pressure plate. The 1600's unit
was very weak. All these parts will run you $200.00 or less. It's also
suggested that you resurface the pressure plate. At least inspect it
closely.

Victor
70 SRL 31113136
Los Angeles
http://albums.photopoint.com/j/AlbumList?u=123073
SoCalROC http://www.ameri-eagle.com/datsun/