Sounds like a good plan to me. I don' want to be pulling the enine any more
than I have to.
Do you guys know of anyone selling a 5-speed and the needed mounts?
Arthur
----- Original Message -----
From: Victor Laury <vlaury@earthlink.net>
To: Arthur <maybee@zebra.net>
Cc: <datsun-roadsters@autox.team.net>
Sent: Sunday, March 04, 2001 6:02 PM
Subject: Re: Newbie
> >once it starts slipping really bad, won't you glaze the assembly
> ---------
> Arthur,
>
> True, or worse you can wear to the rivets and cut the pressure plate and
fly
> wheel.
>
> But, You don't want to do this job twice. Pull the engine and replace the
> pressure, clutch disk, Throw out bearing and guide bush with new parts. I
> strongly suggest that you upgrade to a 2000 pressure plate. The 1600's
unit
> was very weak. All these parts will run you $200.00 or less. It's also
> suggested that you resurface the pressure plate. At least inspect it
> closely.
>
> Victor
> 70 SRL 31113136
> Los Angeles
> http://albums.photopoint.com/j/AlbumList?u=123073
> SoCalROC http://www.ameri-eagle.com/datsun/
|