It is (I had asked Terry in a pmail)... oddly, my TR3A clutch will only work
w/o that spring. Leave the spring off and it works just fine - put it on
there and it does not disengage. Not sure why... perhaps a broken but
jagged clutch fork pin? Been that way for 25 years.
Geo
----- Original Message -----
From: "Ed Woods" <fogbro1@comcast.net>
To: <Dave1massey@cs.com>; <terryrs@comcast.net>; <Triumphs@autox.team.net>
Sent: Wednesday, June 20, 2007 3:03 PM
Subject: Re: [TR] Clutch Adjustment
> ...and of course the slave cylinder return spring is in place, the one
> that is attached to the linkage and causes the slave cylinder piston to
> bottom when the clutch pedal is released.....
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|