Re: Wrenches (spanners in the UK)

["\"Mr. Mike\" Passaretti" <passaretti@sol.med.ge.com>]

>>>>> "jim" == jim bauder <jimbpps@worldnet.att.net> writes:

    jim> Anyone planning to work on their SU's, especially those with
    jim> the threaded fastners on the fuel lines (as opposed to the
    jim> press fit rubber fuel lines as used in the 1959 and later TRs),
    jim> should have at least the four following sizes; 1/4W, 5/16W,
    jim> 3/8W, and 7/16W. These were available from Sears in the past
    jim> but are probably now available only from the speciality tool
    jim> suppliers; i.e., Snap-On, etc.

I second this recommendation.  Sears had a kit with a 1/4-5/16, a
3/8-7/16 and a 1/2-9/16 W open end a few months ago when I was there.
$15.99 the set as I recall...
                                                                -MM