6pack
[Top] [All Lists]

Re: [6pack] Recommendation for a folding engine crane ?

To: vance.navarrette@intel.com, stan.foster@hp.com, 6pack@autox.team.net
Subject: Re: [6pack] Recommendation for a folding engine crane ?
From: acekraut11@aol.com
Date: Mon, 26 Nov 2007 13:02:21 -0500
 If you dont have a suitable joist you can always attach the hoist to an 8' or 
6' length of 4X4 or 6X6 and lay that length of wood across multiple joists to 
spread the load.

Aaron


 


Aaron Cropley
71 TR6 (Throttle Body Injection!)
http://www.triumphowners.com/108
2002 Mini Cooper S
Topsham, Maine

 


 

-----Original Message-----
From: Navarrette, Vance <vance.navarrette@intel.com>
To: Foster, Stan <stan.foster@hp.com>; 6pack <6pack@autox.team.net>
Sent: Mon, 26 Nov 2007 11:48 am
Subject: RE: [6pack] Recommendation for a folding engine crane ?










    Stan:

    Here is my solution, which may or may not work for you.

    I got a one ton hoist, and 4 feet of suitably rated chain. I
wrapped the chain around the main joist (4x8") in my garage, and place
the hoist on it, then use the hoist to pull the engine and transmission.
It all fits in a box about the size of two shoe boxes when I don't need
it.
    Not only is this half the cost of a crane type engine hoist, the
storage requirements are minimal, and setup is easier than a folding
crane that has heavy steel legs, etc that must be disconnected for
storage.
    This pre-supposes of course that you have a garage with a
suitable joist. While usage is less convenient than a traditional engine
hoist (you must push the car under the hoist, instead of bringing the
hoist to the car, for example) the storage requirements were my biggest
issue, hence my willingness to do things in a less convenient manner.

    Vance


-----Original Message-----
From: owner-6pack@Autox.Team.Net [mailto:owner-6pack@Autox.Team.Net] On
Behalf Of Foster, Stan
Sent: November 26, 2007 9:18 AM
To: 6pack
Subject: [6pack] Recommendation for a folding engine crane ?

I wonder if anyone has a recommendation for a folding engine crane for
around
$150 or less that is known to be capable of removing a TR6 engine and
tranny
with OD. I have no practical limit wrt headroom but I do have space
constraints.

I checked with Taylor rental and they want $50 a day to rent a crane
that I
will probably need four times (removal, loading for transportation,
unloading,
installation) so in the end it will be more convenient and no more
expensive
to buy one as long as it collapses pretty good for storage.

The main issue seems to be boom length to reach to a point above the
rear
engine lifting eye.

Stan





 


________________________________________________________________________
Email and AIM finally together. You've gotta check out free AOL Mail! - 
http://mail.aol.com




<Prev in Thread] Current Thread [Next in Thread>