In a message dated 8/14/02 11:07:55 AM Eastern Daylight Time,
nfreeman@baincapital.com writes:
<< drained the oil,
but went to change hte filter, (spin on adapter) and Ill be damned if I can
get it to budge...really on super tight... >>
One of the tricks is to apply steady pressure to the filter. This allows the
rubber seal to slide across the filter base. Steady pressure works much
better than a quick hard pull. Try not to crush or puncture the filter as
this will reduce leverage. Crushing and screwdriver through the can are a
last resort.
When gripping the can with a strap wrench, keep the strap near either end,
the filter is the strongest at this point.
When reinstalling the filter, hand tighten only. 3/4 turn from initial
gasket contact is plenty. Over tightening can lead to the gasket pushing out
and causing a leak.
Harold
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|