| To: | triumphs@autox.team.net |
|---|---|
| Subject: | TR-6 Accelerator shaft bushings ?? |
| From: | flarsen@uclink.berkeley.edu (Flemming Larsen) |
| Date: | Wed, 20 Mar 1996 14:35:56 -0800 |
| Cc: | british-cars@autox.team.net |
I'm about to embark on a mission to replace the worn out accelerator shaft bushings on my (LHD) late 74 (CF27518U) Triumph (with a hole in the boot) TR-6. Anyone been there, done that? Are there any special tricks to doing this? Any special tools (Dremel? BFH?) needed? Thanks! -- Flemming Larsen flarsen@uclink.berkeley.edu |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | BOUNCE triumphs: Non-member submission from [WATSON@wmich.edu], Mark J Bradakis |
|---|---|
| Next by Date: | Spitfire Engine compartment valance stuff, Alan Coleman |
| Previous by Thread: | BOUNCE triumphs: Non-member submission from [WATSON@wmich.edu], Mark J Bradakis |
| Next by Thread: | Re: TR-6 Accelerator shaft bushings ??, Philip E. Barnes |
| Indexes: | [Date] [Thread] [Top] [All Lists] |