nobbc
[Top] [All Lists]

Re: [Nobbc] Machine shop

To: "North Bay British Car Club" <nobbc@autox.team.net>
Subject: Re: [Nobbc] Machine shop
From: cmurphy68@hotmail.com
Date: Thu, 17 Feb 2011 22:38:43 +0000
Thanks for the replies.  I spoke to jerry at JNW and got a quote for the work, 
and also at Seven Enterprises in Auburn.  Seven had a lower quote, even 
accounting for shipping both ways (over 100# with block, crank for sizing, 
pistons and rods).  Jack at Seven said they can usually avoid having to hone 
the crank saddles and caps but would check them for free with the other work 
being done. Also included surfacing the block, which I didn't ask JNW to quote, 
but it could use it.  Since Seven is a Mini specialist, it seems like an easy 
decision.  Good to know about JNW for future local machining needs though!
Sent via BlackBerry by AT&T

-----Original Message-----
From: gtwincams@gmail.com
Sender: nobbc-bounces@autox.team.net
Date: Thu, 17 Feb 2011 05:36:13 
To: North Bay British Car Club<nobbc@autox.team.net>
Reply-To: North Bay British Car Club <nobbc@autox.team.net>
Subject: Re: [Nobbc] Machine shop

Craig,
I have used JNW engine on Piner with good success for Lotus projects. I also 
held a tech session at Jerry's shop for club members, who got a good 
introduction to his work and capabilities. I know of two other members who have 
used his services since the tech session.
All of your needs are well within his abilities. Cost is reasonable but not 
cut-rate. Tell him Greg Tatarian with the Lotus twincams, and from the NOBBC, 
sent you.
Greg
------Original Message------
From: craig murphy
Sender: nobbc-bounces@autox.team.net
To: North Bay British Car Club
ReplyTo: North Bay British Car Club
Subject: [Nobbc] Machine shop
Sent: Feb 16, 2011 8:02 PM

Hello,
I'm looking for a recommendation of a good, reasonably priced machine shop or
retired machinist working out of his garage for some engine work for my '65
Mini Cooper S.  I need to have the main journals line-honed as well as the rod
journals honed, new cam shaft bearings pressed in and possibly a light
resurfacing of the block.
Thanks in advance!
Craig Murphy1965 Morris Cooper S
_______________________________________________
Nobbc@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: 
http://autox.team.net/mailman/options/nobbc/gtwincams@gmail.com

Sent via BlackBerry by AT&T
_______________________________________________
Nobbc@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: 
http://autox.team.net/mailman/options/nobbc/cmurphy68@hotmail.com
_______________________________________________
Nobbc@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>