Re: [Mg-t] 54 TF engine timing

["spook01" <spook01@comcast.net>]

I think he means 5-6 btdc crank degrees at idle and 35 total advance, crank 
degrees, at 3000 rpm.
Best,
Ray

----- Original Message ----- 
From: "Dave and Liz DuBois" <ddubois@sinclair.net>
To: "Ed's Shop" <shop@justbrits.com>
Cc: <mg-t@autox.team.net>
Sent: Saturday, May 24, 2008 9:28 PM
Subject: Re: [Mg-t] 54 TF engine timing


> Since the XPAG/XPEG engines only have a single timing point, one either
> adjusts them statically or uses a dial back timing light to set the
> timing.  Since i have a dial back timing light, I use that to set the
> timing at about 50 - 60 BTDC at idle and a total of  350 BTDC at around
> 2800 rpm - 3000 rpm.
>
> Cheers,
> Dave
> _______________________________________________
>
> Support Team.Net  http://www.team.net/donate.html
>
> Mg-t@autox.team.net
> http://autox.team.net/mailman/listinfo/mg-t
>
> Archives at http://www.team.net/archive 
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

Mg-t@autox.team.net
http://autox.team.net/mailman/listinfo/mg-t

Archives at http://www.team.net/archive