Re: [Mg-t] 54 TF engine timing

[Bud Krueger <budkrueger@comcast.net>]

Dave and Liz DuBois wrote:
> Since the XPAG/XPEG engines only have a single timing point, one either 
> adjusts them statically or uses a dial back timing light to set the 
> timing.  Since i have a dial back timing light, I use that to set the 
> timing at about 50 - 60 BTDC at idle and a total of  350 BTDC at around 
> 2800 rpm - 3000 rpm.
>
> Cheers,
> Dave
> _______________________________________________
>
>   
Uh Dave, I think you may have left out some decimal points.  Perhaps 5 - 
6 0 at idle and 350 at 3000?

Bud
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

Mg-t@autox.team.net
http://autox.team.net/mailman/listinfo/mg-t

Archives at http://www.team.net/archive