land-speed
[Top] [All Lists]

Re: rings rotating?

To: Want1937hd@aol.com
Subject: Re: rings rotating?
From: john robinson <john@engr.wisc.edu>
Date: Fri, 30 May 2003 10:09:47 -0500
no I did understand that it was a real question, and did say "tongue in 
cheek". I was not slighting your question in the least,  your question is 
"good real world and honest". another engine/ring movement question on the 
same serious lines as your question, (kind of a stretch though) would be a 
rotating radial aircraft engine, where the crank is stationary, and the 
block rotates....I don't know the answers, so the questions are asked...

At 10:37 AM 5/30/2003 -0400, you wrote:
>In a message dated 5/30/03 9:59:32 AM Eastern Daylight Time, 
>john@engr.wisc.edu writes:
>
>>
>>Tongue in cheek, or in australia?
>>
>>but you have a good real world question, I just don't have an answer....
>
>
>No, that was an honest question, just seams to me that a canted cylinder 
>vs a vertical would act differently. Bob in connecticut

           John Robinson, Mechanician
   Mechanical Engineering University of Wisconsin
                 1513 University Ave.
                  Madison, Wi. 53706
                     608-262-3606
            Current World Land Speed Record Holder
                  Bonneville Salt Flats
           H/GCC 92 cu.in. 1980 Dodge Colt
                  144.396 MPH set 2000
       MPS-PG 441 c.c. 1967 BSA Victor Motorcycle
                     95.193 MPH set 2001
                 Antarctic Ice Driller Oct02-Jan03

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/land-speed
///  what is needed.  It isn't that difficult, folks.


<Prev in Thread] Current Thread [Next in Thread>