|
| Be sure to follow the included instructions regarding leak testing
| BEFORE putting fluid into the Eezibleed. I got over confident about
| this after a bit and ended up making a big mess. 10psi is plenty of
| pressure. Don't drive yourself nuts trying to seal at 20psi. These
| reservoirs were not designed to be pressure sealed.
|
| Roland
|
with the LARGE number of square inches in the large plastic reservoir
of a GT6, I think even 10 psi might be a lot. Also the reservoir is
"sealed" to the master cylinder with two o-rings which tend to leak
much pressure might aggravate the leak porential. /dick
|