I believe there are 2 types of the mainshaft for an A-type O/D gearbox of the
TR6. The change is somewhere in the 1972 model en
later on a J-type was fitted. Part no of the latest A-type main shaft is
UKC1933. It has the smaller tip to the inputshaft bearing.
Marcel
----- Oorspronkelijk bericht -----
Van: "fot" <fot at autox.team.net>
Aan: "fot" <fot at autox.team.net>, "Greg Blake" <gblake58tr3 at icloud.com>
Verzonden: Zondag 24 december 2017 13:59:08
Onderwerp: Re: [Fot] TR type A OD
Greg,
You're not using the excellent article on the A type overdrive found on the
Buckeye Triumphs technical site.
Ed Woods
> On December 23, 2017 at 10:50 PM Greg Blake via Fot <fot at autox.team.net>
> wrote:
>
>
> I am attempting to rebuild an A type OD over the holiday weekend. I tried to
> separate the rear OD housing from the main OD housing after removing the rear
> output flange and speedo drive. Once i removed the 6 nuts and washers, I had
> to tap the studs with a brass drift to get the rear housing to separate from
> the main housing. But now i can't get the rear OD housing to come completely
> off. I can get about a 1/4" gap between the rear and main housing but it
> won't come all the way off. What am I doing wrong?
>
> Thanks. Greg
>
> Sent from my iPhone
> _______________________________________________
> fot at autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/fogbro1 at
> comcast.net
>
>
_______________________________________________
fot at autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|