Dave
they look and feel good ,don't they !!!! I found the same with my Moto
Lita when I inastalled it; I haven't gotten around to adjusting the taper
yet
Tom 75 tr6
----- Original Message -----
From: "David Friedlander" <forzion@maine.rr.com>
To: <6pack@autox.team.net>
Sent: Monday, March 24, 2008 5:39 PM
Subject: [6pack] Moto Lita Hub install....
> Hey List!
>
> I have pulled off m stock steering hub and wheel and am trying to
> replace it with a new Moto Lita model. I note that, upon attempting to
> install the new hub, the base of the new hub leaves quite a gap (0.300"
> ?), rather than seating flush against the horn ring/folded tabs steering
> column face. Is there a 'trick' to this or has anyone installed a
> MotoLita hub with their new wheel? Perhaps the taper of the hub needs to
> be opened a bit to accommodate the match the shaft taper below the
> splined section?
>
> Hope I'm making myself clear....
>
> Any help appreciated!
>
> Dave Friedlander
> CF25194U+O+TBI
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> 6pack@autox.team.net
> http://autox.team.net/mailman/listinfo/6pack
>
> http://www.team.net/archive
>
> You are subscribed as tomkate@shaw.ca
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|