Tom;
Yes, the Moto Lita quality looks excellent! I don't understand, however: You
say you've already installed yours? How did you get the hub to fit onto the
steering column? On mine, it won't seat all the way down to the face of the
horn ring.... I was considering opening up the taper st the back of the hub to
let it seat completely.....
Dave Friedlander
'74-Six
---- tomkate@shaw.ca wrote:
> Dave
> they look and feel good ,don't they !!!! I found the same with my Moto
> Lita when I installed it; I haven't gotten around to adjusting the taper
> yet
>
> Tom 75 tr6
>
> ----- Original Message -----
> From: "David Friedlander" <forzion@maine.rr.com>
> To: <6pack@autox.team.net>
> Sent: Monday, March 24, 2008 5:39 PM
> Subject: [6pack] Moto Lita Hub install....
>
>
> > Hey List!
> >
> > I have pulled off m stock steering hub and wheel and am trying to
> > replace it with a new Moto Lita model. I note that, upon attempting to
> > install the new hub, the base of the new hub leaves quite a gap (0.300"
> > ?), rather than seating flush against the horn ring/folded tabs steering
> > column face. Is there a 'trick' to this or has anyone installed a
> > MotoLita hub with their new wheel? Perhaps the taper of the hub needs to
> > be opened a bit to accommodate the match the shaft taper below the
> > splined section?
> >
> > Hope I'm making myself clear....
> >
> > Any help appreciated!
> >
> > Dave Friedlander
> > CF25194U+O+TBI
> > _______________________________________________
> >
> > Support Team.Net http://www.team.net/donate.html
> >
> > 6pack@autox.team.net
> > http://autox.team.net/mailman/listinfo/6pack
> >
> > http://www.team.net/archive
> >
> > You are subscribed as tomkate@shaw.ca
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|