Hey List!
I have pulled off m stock steering hub and wheel and am trying to
replace it with a new Moto Lita model. I note that, upon attempting to
install the new hub, the base of the new hub leaves quite a gap (0.300"
?), rather than seating flush against the horn ring/folded tabs steering
column face. Is there a 'trick' to this or has anyone installed a
MotoLita hub with their new wheel? Perhaps the taper of the hub needs to
be opened a bit to accommodate the match the shaft taper below the
splined section?
Hope I'm making myself clear....
Any help appreciated!
Dave Friedlander
CF25194U+O+TBI
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|