Whatever you do, be sure to shock mount the pump to keep the vibration from
being amplified by the body or frame where it is mounted. They are loud
enough without helping it along.
Joe
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of wbeech@flash.net
Sent: Tuesday, April 16, 2013 7:23 AM
To: triumphs@autox.team.net
Subject: [TR] Electric Fuel Pump Placement?
Have decided that I am going to use an electric FP on the TR3B that is
currently under construction. Right now, I have engine in frame and have
successfully had a couple of test starts using just the fuel in the float
bowls. Next step is get the fuel lines installed back to where the tank
will someday be located.
To that end, I was wondering that the collective wisdom is on the location
of an electric FP?
1. Engine compartment seem logical to me although just south of the tank
seems good too, if a bit out of the way.
2. Frame or Body mounting?
3. Firewall or inner fender?
4. Mount in former mechanical FP location?
5. Anyone able to hide the electric FP and route the line through the old
mechanical FP for authenticity?
6. Any other tips on usage or connections?
Any advice or cautions from you who have BTDT are greatly appreciated.
Thanks,
Bill
Bill Beecher
'58 TR3A TS/30766L "Tarbaby"
'62 TR3B TCF/2549L " Aunt B" (in rehab)
www.triumphowners.com/1566 <http://www.triumphowners.com/1566>
'68 Land Rover Series IIa 88" "The Beast"
"Even if you are on the right track, you'll get run over if you just sit
there" Will Rodgers
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
http://autox.team.net/mailman/options/triumphs/spitlist@cox.net
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|