Michael D. Porter schrieb:
>
>
>
> However, there are a couple of things to be considered at the time of a
> valve job. One, which has not been mentioned in this context, is valve
> guides. I would generally recommend replacing the cast-iron guides with
> silicon-bronze-aluminum guides, and installing valve stem seals. The
> guides are not expensive ($3 each, or so), stem seals about a buck
> apiece, and the labor to install the guides is quite small.
I cant find any valve stem seals in my parts catalogues.I had the same problem
with my TRIUMPH motorcycle and found out that Audi 100 valve stem seals fit
well. Has anyone an idea if parts of an other car can be used on a TR 6 motor
head ???
Regards
Gerhard Wiederholl
1969 TR 6
|