I know this isn't strictly a Triumph question, but it will be used on
one-
I’m considering setting up a fuel/air ratio meter using a digital
voltmeter (0-1V), and a Bosch oxygen sensor. How does one connect the
sensor up. Is one lead just connected to a switched, positive side of
the battery, and the reading taken from the center lead and a ground?
Or is some additional wiring required? - I haven’t got the sensor yet,
but plan on buying the universal, unheated sensor. I can’t see spending
$150 for a 0-1V led readout just to test fuel/air readings, and once set
have it sit on the shelf! Any of you wizards out there have any ideas?
Barry Schwartz (San Diego) bschwart@pacbell.net
|