Hi Chris,
Unfortunately, there were no washers under the needle valve to remove.
I ended up shaving a little of the plastic off the float where the
needle valve hits it. I got it down to 3/16". So I was happy.
Roger
Chris King wrote:
> Your float lids may be frm later SU's like mine (FZX1122). The float
> level is adjusted by the thickness of the washers used on the needle
> valve seat. Pull the pivot pin for the float, and then you'll be able
> to remove the float and see the needle valve and seat. The seat has a
> hex so it's easy to remove. If you're lucky, the 1/4" one will have more
> than 1 washer, so you'll be able to adjust the seat by removing one. If
> you're unlucky, you'll need to order thinner washers.
>
> Hope this helps.
>
> -=Chris
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|