On Jun 26, 2011, at 10:25 PM, Pat Horne <pat@hornesystemstx.com> wrote:
> One easy way to test high current cables is to put a volt meter
> across the ends of the cable. When large currents should be flowing
> through the cable the voltage drop across the cable should be a volt
> or two at most.
In car, (which this might as well be) anything over 0.5v is too much,
unless there's a spec that says otherwise. For a startyrr I like to
see. <0.25v.
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|