[Top] [All Lists]

RE: Removing A Keyless Chuck

To:, "''" <>
Subject: RE: Removing A Keyless Chuck
From: "Bedard, Justin" <>
Date: Tue, 06 Jul 1999 15:00:44 -0400

Looking inside the chuck, I do see a Torx screw.  But the directions make no
mention of removing this screw.  Maybe I'll try hammering it a little harder
like Mike Sloane suggested and then attempt to remove this screw.


> ----------
> From:[]
> Sent:         Tuesday, July 06, 1999 1:38 PM
> To:   Bedard, Justin;
> Subject:      Re: Removing A Keyless Chuck
> Justin,
> not sure about the Dewalt brand, but many drills have a screw which holds
> the chuck onto the drill motor...  open up the chuck completely and look
> down into the chuck toward the shaft...  if you see a slotted screw it's
> probably left hand thread and must be removed before removing the chuck.
> The procedure your using is correct and it usually takes a couple of good
> licks
> AFTER the screw is removed
> john

<Prev in Thread] Current Thread [Next in Thread>