Re: questions on skinning a PA tub

["R. Zwart" <zwart@earthlink.net>]

Also should mention that silicone is a no-no wherever you want to paint. 
Cleaning does not always remove and finger prints etc can cause later 
voids........
   BOB

Jack Hardy wrote:

> Don,
>
> I used the original metal for my PA and it does not wrap back up the inside.
> I think you are right that wrapping up the inside would form a water trap. I
> did seal the edges with urethane sealer, 3M 5200 FC as used in boats, some
> silicone (old types) are acidic. Before assembling the wood frame I sealed
> it with polyurethane varnish. I also used metal threaded inserts  ("Rosans")
> or "T" nuts wherever possible to strengthen the joints.
>
> Good luck,
> Jack
>
> ///  unsubscribe/change address requests to majordomo@autox.team.net  or try
> ///  http://www.team.net/cgi-bin/majorcool
> ///  http://www.team.net/mailman/listinfo
> ///  Archives at http://www.team.net/archive/mg-mmm
> ///  Send list postings to mg-mmm@autox.team.net
///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/cgi-bin/majorcool
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-mmm
///  Send list postings to mg-mmm@autox.team.net