No problem cutting holes just big enough to drop the cage thru the floor.
You will be plating them over with large/thick support plates. That's what I
was going to recommend.
Bruce
----- Original Message -----
From: "Linnhoff, Eric" <elinnhoff@smmc.saint-lukes.org>
To: "'Rocky Entriken'" <rocky@tri.net>; "'autox'" <autox@autox.team.net>
Sent: Thursday, June 06, 2002 2:57 PM
Subject: RE: Welding roll cages
> I 'spose one could cut 2" holes in the roof wherever the tube junctions
need
> to be welded. After all, "pretty" is WAY down my list of priorities.
>
> Someone else suggested cutting holes in the floor, dropping the cage
through
> them to weld around the top and then lifting the cage back up and welding
> the floor plates in place.
>
> Hmm, somehow I'd feel safer cutting holes in the roof sheet metal than the
> floor board. Or am I way off base here?
>
> Eric Linnhoff in KC
> #69 STS
> '98 Dodge Neon (see-dan)
> www.geocities.com/eric10mm/KnuckleDragger.html
>
> -----Original Message-----
> Weld it to the roof!
>
> :-)
>
> --Rocky
> **************************************************
> How on earth does one weld around the very top of
> the cage tube junctions
>
> /// unsubscribe/change address requests to majordomo@autox.team.net or
try
> /// http://www.team.net/cgi-bin/majorcool
> /// http://www.team.net/mailman/listinfo
> /// Partial archives at http://www.team.net/archive
> /// Send list postings to autox@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Partial archives at http://www.team.net/archive
|