alpines
[Top] [All Lists]

Re: [Alpines] welding manifold

To: "'Wiencek, Thomas'" <wiencek@anl.gov>, "'?auri Lehtinen'"
Subject: Re: [Alpines] welding manifold
From: "Allan Ballard" <aballard@ix.netcom.com>
Date: Tue, 9 Sep 2008 16:04:11 -0400
I've seen a writeup; will look.

Manifold off a Hunter has to be cut and arc welded minus 10 degrees of
slope to offset the Alpine vertical engine setup. Hunter engines lean
10 degrees.

Acutally that maybe should be 11 to 15 degrees if those carbs prefer a
5 degree slant to work best.

I've seen dcoe's on alpines but never asked which manifold.

As noted the stock alpine manifold will work excespt that port sizes
do not match.

Allan 

-----Original Message-----
From: alpines-bounces+aballard=ix.netcom.com@autox.team.net
[mailto:alpines-bounces+aballard=ix.netcom.com@autox.team.net] On
Behalf Of Wiencek, Thomas
Sent: Tuesday, September 09, 2008 3:22 PM
To: ?auri Lehtinen; Alpines
Subject: Re: [Alpines] welding manifold

The SAOC England has an article about doing this.  Anyone have a copy
handy?

-----Original Message-----
From: alpines-bounces+wiencek=anl.gov@autox.team.net
[mailto:alpines-bounces+wiencek=anl.gov@autox.team.net] On Behalf Of
?auri Lehtinen
Sent: Tuesday, September 09, 2008 5:03 AM
To: Alpines
Subject: [Alpines] welding manifold

Hi folks,
has anyone cut and welded an aluminium intake manifold?
In theory it could be posseble to cut and weld a H120 dual weber
manifold to fit series Alpine, but I am quite sure the intake channels
do?'t hit if there is a part missing. Has anyone tried?

Lauri, Finland
Alpines@autox.team.net
http://autox.team.net/mailman/listinfo/alpines

http://www.team.net/archive
Alpines@autox.team.net
http://autox.team.net/mailman/listinfo/alpines

http://www.team.net/archive
_______________________________________________
Support Team.Net  http://www.team.net/donate.html

Alpines@autox.team.net
http://autox.team.net/mailman/listinfo/alpines

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>