Ken---Since you are not thinking of replacing the rheo, take a look at joining
the two wires without dropping the dash. I did mine by just removing the radio
for easier access, and then standing on my head...
Dick
-----Original Message-----
From: Ken Davis
Sent: Wednesday, July 29, 2009 7:21 PM
To: Ken Davis, 6pack
Subject: Re: [6pack] Removing Rheostat
Thanks everyone. Looks like I'm going to remove tach, speedo and dash this
w/end.... just to short the wires and bypass the dimmer.
Ken
(...and at 110F, the '6 is just a little warm on the desert highways....)
----- Original Message -----
From: "Ken Davis" <ken@azkiwis.com>
To: "6pack" <6pack@autox.team.net>
Sent: Wednesday, July 29, 2009 12:02
Subject: [6pack] Removing Rheostat
> Dumb Question I'm sure, but how do I remove the dash light Rheostat?
> Mine
> has stopped working a bit more than 1/2 way, and dim is now dark.
>
> The manual /guide says pull the knob off - tried, but didn't want to come.
> is
> there a pin holding it? Where? any tricks I should know? Can I reach
> up to
> it from pass. side, ir is it easier to remove the glove box and go over
> that
> way?
>
>
> Thanks
>
> Ken
> 73TR6
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> 6pack@autox.team.net
> http://autox.team.net/mailman/listinfo/6pack
>
> http://www.team.net/archive
>
> You are subscribed as ken@azkiwis.com
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
You are subscribed as tr6taylor@webtv.net
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|