One and only tool that fits, and you will still only get about 1.1 flat per
bit, is a deep offset box end wrench. Craftsman fits. I remember that was
the excuse to buy that set of wrenches :)
kg
-----Original Message-----
From: owner-triumphs@autox.team.net [mailto:owner-triumphs@autox.team.net]On
Behalf Of KTRIUMPH@aol.com
Sent: Saturday, September 23, 2000 8:59 PM
To: pleask@mailhost.wlc.com
Cc: triumphs@autox.team.net
Subject: Re: Bolts holding TR3 Rad !!!!
In a message dated 9/23/00 11:53:14 PM Eastern Daylight Time,
pleask@mailhost.wlc.com writes:
<< Would someone please wave their magic wand and tell me the easy way to
get
those two darn bolts out holding the Rad it's self in place on a TR3.
I have the "Skid" pan out, but can not fit a wrench in there other than a
1/16 of an inch movement at a time if I'm lucky.
I can get a socket in there but not the ratchet extention due to the lower
frame lip, nor does a Universal fit.
Thanks all.
Pat
>>
Pat
I've done this many times using a 3/8" drive ratchet & U-joint. It is tight
tho'. Not sure offhand of any other way to do this.
Ken Nuelle
58 TR3A
62 TR3B
64 TR4
69 TR6
|