Paul,
Is it a BN1 or BN2?
Either way there are 3 phillips head trim screws per vertical side, not 4.
If you can't find the original screw holes, fit up and predrill the panel
before the carpet is installed noting the locations by making a paper
template or whatever. Then trim the carpet onto the panel. Once the carpet
is on. come back with a needle to find the holes, open them up with an awl
and install the panel into the car.
Rich Chrysler
----- Original Message -----
From: <Fiat500f@aol.com>
To: <Healeys@autox.team.net>
Sent: Friday, July 21, 2006 12:15 AM
Subject: 100-4 assembly advice please...
> Ok, so, I'm at the part of carpet installation where I'm ready to install
> that panel that goes in front of the gearbox main cover. The panel with
> the
> big 1/2 circle arch at the bottom. From various photos I can see that it
> is
> attached with four screws (chrome?) vertically on each side. What I'm
> unclear
> on is how do you drill the holes for the screws? If I put a drill into
> that
> carpet skin of the panel, and try to drill, I'm sure that the drill will
> simply tangle up in carpet and more probably pull a line of carpet out of
> the
> whole piece leaving a nice bare line of no carpet all the way across my
> new
> carpet! So, suggestions?
> Thanks,
> Paul B.
[demime 1.01d removed an attachment of type image/jpeg which had a name of
April 06 pics 013.jpg]
[demime 1.01d removed an attachment of type image/jpeg which had a name of
April 06 pics 004.jpg]
[demime 1.01d removed an attachment of type image/jpeg which had a name of
May06 pics 046.jpg]
|