Ok, so, I'm at the part of carpet installation where I'm ready to install
that panel that goes in front of the gearbox main cover. The panel with the
big 1/2 circle arch at the bottom. From various photos I can see that it is
attached with four screws (chrome?) vertically on each side. What I'm unclear
on is how do you drill the holes for the screws? If I put a drill into that
carpet skin of the panel, and try to drill, I'm sure that the drill will
simply tangle up in carpet and more probably pull a line of carpet out of the
whole piece leaving a nice bare line of no carpet all the way across my new
carpet! So, suggestions?
Thanks,
Paul B.
|