If you put the banjo in a press just a relatively gentle vertical squeeze will
spread the case horizontally and release the diff with little drama.
On Sep 26, 2013, at 7:25 PM, "Joe Boruch" <jaboruch@netzero.net> wrote:
> I have aways been able to pry the diff out with extra large screw drivers as
> pry bars. Joe(B)
>
> From: Scott Janzen <Janzen@REcatalyst.com>
> To: 'Friends of Triumph' Triumph <fot@autox.team.net>
> Subject: [Fot] TR4 diff disassembly
> Date: Thu, 26 Sep 2013 22:12:19 -0400
>
> So, i am pulling apart the rear axle to send it to Southwick for conversion.
> I'm working without a shop manual - and want to pull the differential out of
> the housing. I've removed the bearing caps. Do I need Churchill Spreader
> xyz, and is there a good/cheap substitute? It does not want to pop out with
> the persuasion of a pry bar.
>
> BTW, there's a Detroit locker . . . any special instructions?
> ____________________________________________________________
> 30-second trick for a flat belly
> This daily 30-second trick BOOSTS your body's #1 fat-burning hormone
> http://thirdpartyoffers.netzero.net/TGL3231/5244ecdd827986cdd2c70st04duc
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/billb@bnj.com
>
>
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|