The rope trick works
Tie a rope to the carrier and hang the entire axle from a vise. Use a soft
faced hammer and hit the the housing on both sides of the carrier. The housing
will drop to the floor. Note: don't hang it too high off the ground!!
Todd
Sent from my iPad
On Sep 26, 2013, at 10:12 PM, Scott Janzen <Janzen@REcatalyst.com> wrote:
> So, i am pulling apart the rear axle to send it to Southwick for conversion.
> I'm working without a shop manual - and want to pull the differential out of
> the housing. I've removed the bearing caps. Do I need Churchill Spreader
> xyz, and is there a good/cheap substitute? It does not want to pop out with
> the persuasion of a pry bar.
>
> BTW, there's a Detroit locker . . . any special instructions?
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/fot/alfetta95@optonline.net
>
>
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|