That's what I do.
On Sep 27, 2013, at 7:30 AM, Todd Redmond <alfetta95@optonline.net> wrote:
> The rope trick works
>
> Tie a rope to the carrier and hang the entire axle from a vise. Use a soft
> faced hammer and hit the the housing on both sides of the carrier. The
> housing will drop to the floor. Note: don't hang it too high off the
> ground!!
>
> Todd
>
> Sent from my iPad
>
> On Sep 26, 2013, at 10:12 PM, Scott Janzen <Janzen@REcatalyst.com> wrote:
>
>> So, i am pulling apart the rear axle to send it to Southwick for conversion.
>> I'm working without a shop manual - and want to pull the differential out
>> of the housing. I've removed the bearing caps. Do I need Churchill
>> Spreader xyz, and is there a good/cheap substitute? It does not want to pop
>> out with the persuasion of a pry bar.
>>
>> BTW, there's a Detroit locker . . . any special instructions?
>> _______________________________________________
>> fot@autox.team.net
>>
>> http://www.fot-racing.com
>>
>> Donate: http://www.team.net/donate.html
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe/Manage:
>> http://autox.team.net/mailman/options/fot/alfetta95@optonline.net
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/fot/ablake2@austin.rr.com
>
>
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|