Without a diff spreader... you can use a torch and heat up the perimeter of
the case. It does not take much to expand the cast case by a couple of thou
and the pumpkin will fall out!
Steve Yott
-----Original Message-----
From: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] On
Behalf Of Joe Boruch
Sent: Thursday, September 26, 2013 9:25 PM
To: Janzen@REcatalyst.com
Cc: fot@autox.team.net
Subject: Re: [Fot] TR4 diff disassembly
I have aways been able to pry the diff out with extra large screw drivers as
pry bars. Joe(B)
From: Scott Janzen <Janzen@REcatalyst.com>
To: 'Friends of Triumph' Triumph <fot@autox.team.net>
Subject: [Fot] TR4 diff disassembly
Date: Thu, 26 Sep 2013 22:12:19 -0400
So, i am pulling apart the rear axle to send it to Southwick for conversion.
I'm working without a shop manual - and want to pull the differential out of
the housing. I've removed the bearing caps. Do I need Churchill Spreader
xyz, and is there a good/cheap substitute? It does not want to pop out with
the persuasion of a pry bar.
BTW, there's a Detroit locker . . . any special instructions?
____________________________________________________________
30-second trick for a flat belly
This daily 30-second trick BOOSTS your body's #1 fat-burning hormone
http://thirdpartyoffers.netzero.net/TGL3231/5244ecdd827986cdd2c70st04duc
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|