Well not to start a controversy, but I have one on the bench right now,
torqued down and ready to go, and the mics don't lie.
The liners tend to waist down around the lower register.
Glen
-----Original Message-----
From: tr4racing <tr4racing@googlemail.com>
To: fubog1 <fubog1@aol.com>; johnstydo <johnstydo@gmail.com>
Cc: fot <fot@autox.team.net>
Sent: Tue, Sep 11, 2012 4:26 pm
Subject: Re: [Fot] Never be beaten by equipment
We did a lot of testing with torque plate and we found NO difference with or
without.
Gesendet mit BlackBerry von Vodafone
-----Original Message-----
From: fubog1 <fubog1@aol.com>
Date: Tue, 11 Sep 2012 16:21:56
To: <johnstydo@gmail.com>
Cc: <mmoore@wave1.net>; <jhhasty@gdhs.com>; <tr4racing@googlemail.com>;
<fot@autox.team.net>
Subject: Re: [Fot] Never be beaten by equipment
The other point that should be mentioned is that these liners should be honed
using a torque plate.
They get out of shape once they are clamped down in place.
FWIW I use JE pistons and set them at .004, usually with coated skirts as an
added insurance policy against scuffing.
Glen
-----Original Message-----
From: John Styduhar <johnstydo@gmail.com>
To: fubog1 <fubog1@aol.com>
Cc: mmoore <mmoore@wave1.net>; jhhasty <jhhasty@gdhs.com>; tr4racing
<tr4racing@googlemail.com>; fot <fot@autox.team.net>
Sent: Tue, Sep 11, 2012 2:42 pm
Subject: Re: [Fot] Never be beaten by equipment
My math shows that MadMarx is running .005" piston to wall clearance
(.13mm/25.4
mm/inch=.005. Wiseco's suggested clearance for their forged 87mm slugs is
.004,
but others (BFE) have recommended .006, which is what my machinist is honing
to.
On Tue, Sep 11, 2012 at 1:16 PM, fubog1 <fubog1@aol.com> wrote:
I'll try this again, my reply had too much text.
The manufacturers will call out a recommended clearance, but that's all it
is.
The operating speed, temperatures, cooling systems etc all are variables.
Generally the harder it is run, the more clearance it needs.
Also pistons can scuff during warm-up, under certain conditions, so it's a
good thing to get it up to temp before flogging it hard.
Glen
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/fot/fubog1@aol.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/fot/fot-archive@autox.team.net
|