I run about ..006 for my clearance with Wiesco pistons, they are popular in
the marine industry and they have the same characteristics...or problems
without the clearance..need more room, I also add more clearance to
the connecting rod at the crank so that more oil can be delivered,I was
told it was an old dragster trick..seems to work.
.
On Tue, Sep 11, 2012 at 4:25 PM, <tr4racing@googlemail.com> wrote:
> We did a lot of testing with torque plate and we found NO difference with
> or without.
> Gesendet mit BlackBerry von Vodafone
>
> -----Original Message-----
> From: fubog1 <fubog1@aol.com>
> Date: Tue, 11 Sep 2012 16:21:56
> To: <johnstydo@gmail.com>
> Cc: <mmoore@wave1.net>; <jhhasty@gdhs.com>; <tr4racing@googlemail.com>; <
> fot@autox.team.net>
> Subject: Re: [Fot] Never be beaten by equipment
>
>
> The other point that should be mentioned is that these liners should be
> honed using a torque plate.
> They get out of shape once they are clamped down in place.
> FWIW I use JE pistons and set them at .004, usually with coated skirts as
> an added insurance policy against scuffing.
> Glen
>
>
>
>
>
> -----Original Message-----
> From: John Styduhar <johnstydo@gmail.com>
> To: fubog1 <fubog1@aol.com>
> Cc: mmoore <mmoore@wave1.net>; jhhasty <jhhasty@gdhs.com>; tr4racing <
> tr4racing@googlemail.com>; fot <fot@autox.team.net>
> Sent: Tue, Sep 11, 2012 2:42 pm
> Subject: Re: [Fot] Never be beaten by equipment
>
>
> My math shows that MadMarx is running .005" piston to wall clearance
> (.13mm/25.4 mm/inch=.005. Wiseco's suggested clearance for their forged
> 87mm slugs is .004, but others (BFE) have recommended .006, which is what
> my machinist is honing to.
>
> On Tue, Sep 11, 2012 at 1:16 PM, fubog1 <fubog1@aol.com> wrote:
>
> I'll try this again, my reply had too much text.
> The manufacturers will call out a recommended clearance, but that's all it
> is.
> The operating speed, temperatures, cooling systems etc all are variables.
> Generally the harder it is run, the more clearance it needs.
> Also pistons can scuff during warm-up, under certain conditions, so it's a
> good thing to get it up to temp before flogging it hard.
> Glen
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/fot/rfdeanes@gmail.com
>
>
>
--
rob deanes
TR Racer
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/fot/fot-archive@autox.team.net
|