Julian:
I sent these figures (from my archive) to Bill Mounce, but may have not
copied to the list. The link still works and there seems to be quite a
bit of Weber info on that website.
Ron Tebo
Subject: Re: Weber DGV jetting
Date: Sun, 16 Apr 2000 11:12:16 -0500
From: "Brad Sahr" <bsahr@mediaone.net>
To: "Andrew Gregg" <viber@onix.net>, "Alpines" <alpines@autox.team.net>
Andrew,
I've got a 32/36 DGV 5A and I do not have the mid-range sputter that you are
experiencing. I do have a stumble when I pull away from a stop, but I'm
attributing this to poor engine compression. Here are the Weber 32/36 DGV 5A
jet settings:
Jet Primary Secondary
Main 140 135
Air 165 160
Idle 55 50
E-tube F50 F6
Pump 50 n/a
You can buy jets from Performance Parts Warehouse on the east coast
(http://www.webercarburetors.com/). $25 minimum. My notes indicate $3.50 for
Idle, Air, and Main jets; $10 for E-tubes.
Brad
'64 Series IV Automatic
-----Original Message-----
From: Andrew Gregg <viber@onix.net>
To: Alpines <alpines@autox.team.net>
Date: Saturday, April 15, 2000 1:56 PM
Subject: Weber DGV jetting
>Here I am again with another in my on-going series of Weber questions. The
>car now idles fine and performs quite well with the DGV carb. However, it
>has a sputter in the mid-rpm range which I attribute to a jetting
mis-match.
>(The carb came from a VW Beetle.) Can anyone out there give me the numbers
>from a set of jets that work well in a Series IV Alpine? The name of a
>supplier would also be helpful.
>Thanks,
>Andrew Gregg
>1964 Series IV
>
jacranwell@aol.com wrote:
> Thanks Rich,
>
> I may try those settings myself, as my idle could be better.
>
> Any clues as to the main jests for the 1725?
>
> Julian.
>
>
> -----Original Message-----
> From: rwvose@vcn.com
> To: alpines@autox.team.net
> Sent: Wed, 8 Jul 2009 20:46
> Subject: [Alpines] Weber question
>
>
> Hi Bill,?
> You have the classic symptoms of DGV lean idles. I can't give you specific
>recommendations on jets, but if your 1725cc engine is basically stock and your
>altitude is between sea level and 2000', I'd start with a primary idle size of
>065 or 070 and the secondary idle of 062 or 065. Jets can be purchased from
>Pierce Manifolds or Redline Weber.?
> ?
> Hope this helps,?
> ?
> Rich Vose?
> _______________________________________________?
> Support Team.Net http://www.team.net/donate.html?
> ?
> Alpines@autox.team.net?
> http://autox.team.net/mailman/listinfo/alpines?
> ?
> http://www.team.net/archive?
>
>
> ________________________________________________________________________
> AOL Email goes Mobile! You can now read your AOL Emails whilst on the move.
>Sign up for a free AOL Email account with unlimited storage today.
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Alpines@autox.team.net
> http://autox.team.net/mailman/listinfo/alpines
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Alpines@autox.team.net
http://autox.team.net/mailman/listinfo/alpines
http://www.team.net/archive
|