Hello Jarrid,
If I can find my copy of the drawing I will send it along. Don't have
scanning capacity at the moment, sadly. It may take a few days, but I'll
look for it today if possible. You've been trememndously helpful to me any
number of times, so I hope I can be of help to you. (I would try *anyway,*
even if you *hadn't* been helpful...)
Please bear with my technologically challenged situation.
with Very Best Wishes,
David
PS I'm not holding out on you in any way, shape or fashion!
----Original Message Follows----
From: Jarrid Gross <jarrid_gross@earthlink.net>
To: davidkellogg@hotmail.com
CC: CANISDOG@aol.com, alpines@autox.team.net
Subject: Re: Aluminum Sump QuestionsIMPORTANT
Date: Wed, 16 May 2001 15:57:34 -0700
davidkellogg@hotmail.com wrote:
> By the way, did you consult the factory drawing which shows the 1725 in
> its Alpine GT configuration? This is *IMPORTANT* because the oil pump
> pick-up is differently shaped than the standard 1725 unit. Furthermore,
its
> shaft *may* be longer --to accomodate the greater depth of the new sump--
> and you ought to check this out BEFORE INSTALLING YOUR ENGINE!
Hey!
Are you holding out on me?
Its these types of drawings I'm after here!
I REALLY need the details of the pickup, windage and baffle for the
GT pan.
Care to scan it, or make a copy?
Thx,
Jarrid
_________________________________________________________________
|