Jay,
Thanks for the advice. I'll let you know if I'm successful in removing the
cap.
John
In a message dated 09/24/2001 7:19:18 AM Eastern Daylight Time,
jay_welch@juno.com writes:
> John,
>
> Remove all three of the bolts and tap from below the cover with a drift
> or dull chisel and hammer. Also tap the sides of the cover. It should
> free up. You might want to prelube with PB Blaster or a similar product.
> A little heat on the steel cover should not hurt anything.....just be
> careful as it is aluminum underneath the cover.
>
> Good Luck,
> Jay Welch, Abington MA
> 1971 TR6 project
> 1973 TR6 driver - wanting to "Drive it Hard"
> Member "Cape Cod British Car Club" @
> http://clubs.hemmings.com/capecodbritish/
|