[TR] Red LEDs?

TERRY SMITH terryrs at comcast.net
Wed May 2 08:37:13 MDT 2018

Thank you, Geo and Randall.  I've ordered the resistors.  I take it these are soldered in-line between between the turn signal switch and where the splice is made for front and back for each, left and right, turn signals?  Is there a favorite place to tie into?

> On May 2, 2018 at 9:55 AM Geo Hahn <ahwahneetr at gmail.com> wrote:
>     On Tue, May 1, 2018 at 3:04 PM, TERRY SMITH <terryrs at comcast.net mailto:terryrs at comcast.net > wrote:
>         > > 
> >         Tom and Dave, thank you.  Are you saying that you use a regular flasher unit with the ballast resistor, and that will allow not only the LED's to work, but also the turn signal indicator light on the dash?
> > 
> >     > 
>     That is what I did.  I used connectors to permit a no-cut connection to the original harness.  Mounted magnets to the resistors so I could tuck them out of the way (e.g. on the inner wing, under the apron):
>     Connects from a multiple bullet connector to any handy ground.
>     Geo 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20180502/fea5b579/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Load Resistors.JPG
Type: image/jpeg
Size: 53323 bytes
Desc: not available
URL: <http://autox.team.net/pipermail/triumphs/attachments/20180502/fea5b579/attachment.jpe>

More information about the Triumphs mailing list