[Healeys] Thread size on shift knob.

[Bob Spidell]

Tore my generator down the other day; surprised to find that the pulley retaining nut is BSF (20TPI). 

I believe all the fuel fittings are Whitworth (fortunately, a 13/16" socket works well on the banjo bolts). 


----- Original Message -----

From: "Michael Salter" <michaelsalter at gmail.com> 
To: "Ed O'Neal" <Ed at wadsworthoneal.com> 
Cc: "healeys" <Healeys at autox.team.net> 
Sent: Monday, December 12, 2016 8:17:56 AM 
Subject: Re: [Healeys] Thread size on shift knob. 

Coarse threads... 
Off topic, but there are some other coarse threads that I can think of... 
The RH and LH threads in the door check assemblies. 
The head studs into the block and other studs into cast iron components. 
And oddly the generator end bracket uses a BSW thread for the tensioner locking bolt... 
All for good reasons I suppose...:-) 

Michael S 
BN1 174 


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20161212/4f5c2013/attachment.html>