[Healeys] Thread size on shift knob.

Ed O'Neal Ed at wadsworthoneal.com
Mon Dec 12 15:20:19 MST 2016


Michael is right, now that I think about it.  But I’m not sure on the door hold-opens.


From: Bob Spidell [mailto:bspidell at comcast.net]
Sent: Monday, December 12, 2016 3:38 PM
To: Michael Salter
Cc: Ed O'Neal; healeys
Subject: Re: [Healeys] Thread size on shift knob.

Tore my generator down the other day; surprised to find that the pulley retaining nut is BSF (20TPI).

I believe all the fuel fittings are Whitworth (fortunately, a 13/16" socket works well on the banjo bolts).


________________________________
From: "Michael Salter" <michaelsalter at gmail.com<mailto:michaelsalter at gmail.com>>
To: "Ed O'Neal" <Ed at wadsworthoneal.com<mailto:Ed at wadsworthoneal.com>>
Cc: "healeys" <Healeys at autox.team.net<mailto:Healeys at autox.team.net>>
Sent: Monday, December 12, 2016 8:17:56 AM
Subject: Re: [Healeys] Thread size on shift knob.

Coarse threads...
Off topic, but there are some other coarse threads that I can think of...
The RH and LH threads in the door check assemblies.
The head studs into the block and other studs into cast iron components.
And oddly the generator end bracket uses a BSW thread for the tensioner locking bolt...
All for good reasons I suppose...:-)

Michael S
BN1 174


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20161212/bbb791cb/attachment.html>


More information about the Healeys mailing list