. I took some paper and measured it up no problems. In my experience
> the 'U' holes were not directly below the two holes for the TR4 shield
badge
> but offset by about 7mm (approx.)
>
It seems to me, when I test fit the new letters for my Herald, that they are
just a little bit "crookedy" Could this be because they are not exact
reproductions, or just the holes were badly drilled at the factory, or am I
not looking at them right?
Scott
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
|