Re: Transmission Disassembly Question

[Brian Sanborn <sanborn@net1plus.com>]

Thanks Mike,

I think it came out in one piece... I will measure tonight to make sure.  The 
taper pin was in VERY tight and I think that hole in the clutch shaft has been 
distorted and is rubbing on the internal surface of the fork base.  Once I get 
it past the center point I hope it gets easier.  I have only mananged an inch 
so far after about an hour of trying.

Do think the fork could break if continue to do what I described.

Brian Sanborn
62 TR4 CT16260L - Groton, MA
sanborn@net1plus.com