TR6 wood fascia

["Frank & Carol Bandre" <bandrece@accessus.net>]

To all

I am currently stripping the old varnish from the wood fascia of my TR6.  I
have found several small areas the the veneer had been patched by a DPO. 
If I can;t get the stain to match, I may re-veneer the panel.  The question
is: Can I glue the new veneer directly onto the old or should the old be
revoved and the plywood subsurface cleaned.  Also, I would most likely use
an X-Acto knive to cut the holes.  Is this the best way?

Frank

'76 TR6 CF57005U