Hi all
If this reaches the list it will be my first sucessful post for 2
years or so as I have had my posts turned away due to email aliasing
problems here. Thanks Mark for resolving this.
The Aussie export post of mine was related to a very old question regarding
importing cars to Aus. My experience is bringing cars to the US from
the UK. Mark only recently forward it to the list.
James asked about floors. I've always understood that floor
replacement, like rocker (UK trans. "sill"), should be done with the car
very thoroughly supported under the frame, outriggers, sills and
floors. Also only work on one side at a time to retain as much
rigidity as possible.
I think that this accounts for the door and panel alignment problems I
experience.....
Neil
'73 Spitfire MkIV 1296cc RHD.
Austin, TX
Neil Penberthy
Liant Software
Phone: 800-762-6265 (800 RMCOBOL) x5574
Email: n.penberthy@liant.com
|