RE: TR6 throttle link bushings

[cstretz@FreeMark.COM (Chad M. Stretz)]

I spoke with a couple of people that suggested splitting the 
bushings, too.  I chose the boiling method and it works 
great.  Using a small flat screwdriver, I SLOWLY worked them 
into place.  You may have to run around the car from inside 
to outside 734 times, but patience is key.  I did notice 
however, that my throttle shaft tended to stick on the 
bushings a little.  I would suggest that you lube them well 
before putting the shaft back in to avoid this.         

CStretz@freemark.com