It is drilling acurate holes in the new plastic tunnel that are same as old
cardborad one.
I cut front 2 in. off my old tunnel with jig saw. Then used this piece to
lay out the holes in the new tunnel.
Do not forget to put in a new seal around the front arch and on the floor
pans. Glue seals to body. Also look at your boot rubber for shifter. Good
time to replace that if torn.
To install, put in reverse, with emergency brake down (off). Lower tunnel
down, pry brake handle up and over, now put in first gear.
Jerry Lloyd
74 TR6
Seattle
|