spridgets
[Top] [All Lists]

Re: Pressure Failure Switch

To: "robert weeks" <robert@woozy.com>, <Don.Clark@fluordaniel.com>, <spridgets@Autox.Team.Net>, "ncannon" <ncannon@cvn.net>
Subject: Re: Pressure Failure Switch
From: "Tom Zuchowski" <tzuchow@ibm.net>
Date: Wed, 15 Jul 1998 19:24:18 -0400
Reply-to: "Tom Zuchowski" <tzuchow@ibm.net>
Sender: owner-spridgets@Autox.Team.Net
I found an ordinary threaded pipe plug fits the pressure switch hole just
fine. I just took the switch and found a match.

The Moss kit also includes new seals, I believe.

Tom Zuchowski
'61 Bugeye
Clemmons, NC

----------
> From: robert weeks <robert@woozy.com>
> To: Don.Clark@fluordaniel.com; spridgets@Autox.Team.Net; ncannon
<ncannon@cvn.net>
> Subject: Re: Pressure Failure Switch
> Date: Monday, July 13, 1998 9:05 AM
> 
> Hello,
> 
> Moss does have a rebuild kit for this, basically it's just the O rings.
My
> catalog shows the new brass piece as being $483 -- that's absurd when you
> consider what's involved with manufacturing that part.
> 
> What I'd like to know is if anyone has fashioned some sort of metal screw
/
> plug to replace the plastic switch. My switch has never worked and I
don't
> see any reason to replace it -- I'm not a big fan of idiot lights, call
me
> a DPO if you will, but since I don't ever plan on selling the car I
figure
> I can make this modification without karmic retribution.
> 
> Also, I have a spare one of these that I pulled off of my parts car, but
> instead of O rings it has rubber sleeves which seem to not be
rebuildable,
> has anyone seen a rebuild kit for this style?
> 
> Thanks,
> 
> Robert Weeks
> Durham NC
> 1969 Midget
> 1968-70 Abitza
> http://www.woozy.com/midget/
> 
> 
> 
> At 6:28 AM -0400 7/13/98, Don.Clark@fluordaniel.com wrote:
> >     Norm,
> >
> >     I am very interested in this answer.  I am restoring my '72 Midget
and
> >     this past weekend, after replacing my master cylinder and bleeding
the
> >     brakes, brake fluid comes flowing out of this switch.  It is
plugged
> >     for now with a bolt.  I hope I don't have to replace the $450.00
> >     pressure warning assembly.
> >
> >     Don
> >     '72 Midget
> >
> >
> >Subject: Pressure Failure Switch
> >Author:  ncannon@cvn.net (ncannon) at fdinet
> >Date:    7/11/98 8:11 AM
> >
> >
> >While flushing the brake lines on my 1976 MG Midget I noticed a drip
> >from the pressure failure switch in the pressure warning assembly. I
> >added a little air pressure and a pin hole stream of alcohol flowed from
> >the switch.  Can I replace just the switch or should I replace or
> >rebuild the entire assembly?
> >
> >Thanks in advance for all help!
> >Norm
> >
> 
> 
> 

<Prev in Thread] Current Thread [Next in Thread>