To: | Carter Shore <clshore@yahoo.com> |
---|---|
Subject: | Re: Drain Plug Location |
From: | Joe Curry <spitlist@gte.net> |
Date: | Fri, 27 Oct 2000 19:17:27 -0700 |
Carter, Is the flat spot directly under the freeze plug or about an inch or so toward the front of the engine? The one closer to the front is where the blow-by pipe was capped off. Joe Carter Shore wrote: > > Not so fast, I'm looking at a 1500 block dangling from > the end of my lift, and there is no drain, only a flat > spot in the block casting where it should be. > Thanks, BLMC bean counters! |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: 1500 Cylinder head, Ken C |
---|---|
Next by Date: | Re: 1500 Cylinder head, Carter Shore |
Previous by Thread: | Re: Drain Plug Location, Carter Shore |
Next by Thread: | Re: Drain Plug Location, Carter Shore |
Indexes: | [Date] [Thread] [Top] [All Lists] |