Re: [Shop-talk] Drilling a hole in aluminum oil pan

[Donald H Locker <dhlocker@comcast.net>]

I agree with what Bob said.

Engine's on a stand, so it is accessible. And it sounds like the
alternative you've conceived is far more complex than dropping the pan.
Ask yourself what you'd do if you were the machine shop you trusted with
that sweet lump.

Donald.

*Plain Text* email -- it's an accessibility issue
() no proprietary attachments; no html mail
/\ <https://www.georgedillon.com/web/html_email_is_evil.shtml>

On 2020-10-03 11:56 a.m., Miq Millman wrote:
> Here's what I want to do:
> 
> Drill a 23/32' hole in the side of the oil pan for the (1/2 NPT-AN10
> steel braided line that allows the oil from the turbo back into the
> block.  I have the NPT tap ready.
> 
> Here are the complications:
> 
> 1) pan is bolted and sealed to the block -- I would rather not remove it
> 2) oil pan is aluminum not steel
> 3) there is already a threaded hole for 3/8 NPT
> 4) engine is newly built long block, with most of the ancillaries still
> to be attached, on an engine stand.
> 5) there is an additional hole on the opposite side of the pan for an
> oil temp sensor
> 
> Here is what I am thinking:
> 
> 1) coat the drill bit in some red grease to collect aluminum shavings
> 2) seal off water and vacuum passages with tape
> 3) set air compressor to something very low, like 20 psi, and thread
> into the oil sensor hole (1/8 NPT)
> 4) fabricobble up a reduced hose to the shop vac line and point that at
> the drilling point
> 5) drill in short bursts, possibly cleaning the bit and grease each
> time, and reapplying grease
> 6) after I tap the hole (also a challenge due to the length of the tap
> and the baffle inside the pan) dump 5-6 quarts of the cheapest 10 w oil
> at the FLAPS and kind of "slosh" it around by slightly rotating the
> engine on the stand, drain and repeat again
> 7) check second pot of drained oil for metal shavings, if found try gas
> or diesel followed by 3rd round of cheap oil flush
> 
> Open to options and opinions.  Including telling me not to be an idiot
> with my $8000 engine and just pull the pan.
> 
> --
> __
> Miq Millman   miq@bigllama.com <mailto:miq@bigllama.com>
> Tualatin, ORÂ  Big Llama Productions
> 
> _______________________________________________
> 
> Shop-talk@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation  $12.96
> Archive: http://www.team.net/pipermail/shop-talk http://autox.team.net/archive
> 
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/shop-talk/dhlocker@comcast.net
> 
_______________________________________________

Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.96
Archive: http://www.team.net/pipermail/shop-talk http://autox.team.net/archive

Unsubscribe/Manage: 
http://autox.team.net/mailman/options/shop-talk/mharc@autox.team.net